Special Access Project part 5

14 Sep 2015

DK2 support has increased tremendously in the last couple weeks, with Betas of Flyinside (a DK2 driver for FSX) being released aswell as a new DK2 SDK with la de da fancy GPU support corresponding with a new Nvidia driver release. Thats 3 drivers all playing nicely for 75fps FSX in head tracked DK2 VR (virtual reality) (albiet with all the terrain and other effects turned down).

Now looking into the hardware software interface

error: terradactl support not found

No but really, umm here

  • From the DIY 6DOF Motion Platform, quote
    "The first one was with the thanos board, the second one with the dimension engineering kangaroos."

    So theres 2 hardware solutions, thanos board which I believe works with x-sim as a PID and the dimension engineering kangaroos which are also a PID for DC motor controllers

  • There is x-sim, which is a data interface for FSX, although the DIY 6DOF Motion Platform above doesn’t necessarily say good things about the thanos board, which also has like 0 support on its website, get on that thanos. Which leads me to look for a hardware interface which will work with a quadrature encoder since thats a requirement
  • Also, this 6 DOF Motion Software, referenced at the DIY 6DOF Motion Platform entry with the dimension engineering kangaroos, although specifically for 6dof platforms
  • what ever the fuck this is.

So I figure I need to learn about X-Sim and what it outputs, I need roll and pitch output, then I need a PID to work with the quadrature encoders to output to a motor driver. Then I can work out mass of the cockpit and torque requirements. How plane pitch/roll data aligns with torque requirements, then I can look into motor and gear selection, then I can look more seriously at motor driving PID firmware.

Looked into motor frame design with a horizontal roll motor:

horiz_motor

Leave a Reply

Your email address will not be published. Required fields are marked *